![]() If you suspect I have missed something, or want any terminal outputs, etc. I have seen other examples using the PI-2 Bus itself, but I would prefer to use the pins specifically designated for that purpose. Perhaps I suck at finding stuff in forums/google. I have been trying to find examples from other pine64 boards to see if I could adapt it, but it appears that no other board had a dedicated 12v 2pin fan port. Does this imply that I have a defective sensor, or is is just not enabled.ģ. until you run some cpu tasks - which you can feel the change in temperature in the mid-profile heatsink just by touching it, yet the value hasn't budged, so I am skeptical that it is actually reading a value. BUT, 'sensors viewer' is reading something: "ACPI v zones" and displays a thermal_zone0 and thermal_zone1 are showing a realiztic looking 38C. ![]() I also installed xsensors, psensor, neither of which were able to locate a temperature sensor either. I tried to install fancontrol as part of lm-sensors but lm-sensors returned that there were no sensors installed, which prevented fancontrol or pwmconfig from running. (Pine64 sold a small 12V fan made for the rockpro64 board, but there doesnt seem to be an explanation on how to turn it on or enable the pins.) Could it possibly be part of or an extension of the pi-2 bus?Ģ. I feel like I am missing something fairly basic, but I havent been able to find another source for this information.ġ. I have a couple of extra questions regarding fan control. You also can use the 4pin 12V socket for Fan but this si always on. This is a PWM control fan port and speed can be controlled by software. There is a 2 Pin 12V fan port at the Pi2 bus. When I checked the voltage on the connector labelled FAN, there is no voltage.Ĭurrently I am taking the 12 volts from the 4 pin socket behind the power socket. Fan Control is, for our money, the best fan control software available for modern gaming rigs.
0 Comments
Leave a Reply. |